Description
Replaces the driving axle crankpins on Markits wheels. To assemble: screw the crankpin into the wheel; drop on the coupling and connecting rods (2.6mm diameter holes needed in these); screw on the crank – with the wheel at bottom dead centre, the crank points forwards a few degrees, and the hex hole should set this for you; screw the eccentric rod (1.0mm diameter hole needed in this) to the small end of the crank. You will need the NUTSPINNER’s 14BA fitting. The forward setting applies on both sides of the loco – don’t copy an RTR loco, as they’re often wrong!