Description
Replaces the driving axle crankpins on Markits wheels. To assemble: screw the crankpin into the wheel; drop on the coupling and connecting rods (2.6mm diameter holes needed in these); screw on the crank – with the wheel at bottom dead centre, the crank points forwards a few degrees, and the hex hole should set this for you; screw the eccentric rod (1.0mm diameter hole needed in this) to the small end of the crank. You will need a 1mm Allen key. The forward setting applies on both sides of the loco – don’t copy an RTR loco, as they’re often wrong!
